Fixtures and other items are fastened to concrete, steel, and concrete blocks using gas-actuated fasteners. Gas-actuated fasteners are installed using a particular kind of nail gun called a gas-actuated concrete nailer, also referred to as direct fastening. The force of pneumatic tools is delivered by a gas fuel cell but without the hoses and compressors. This operates much more quietly and saves time and money.
Continue reading this full article to know more about the gas actuated fastening tool.
Gas Actuated Fastening Tool
For a quick and secure installation, use the Fischer gas-actuated fastening tool. The tool needs to be placed perpendicular to the work surface for the best installation and the supporting stand is attached but can be removed to drive nails in confined spaces. Also, the device will function in the specified temperature range. -7°C to +50°C and the tool has the following measurements: L 336 mm x W 121 mm x H 404 mm.
Advantages of Gas Actuated System
- The gas-actuated fastening tool from Fischer has a 100-joule power tool. Correct penetration into the working surface is ensured by FGC 100, even for applications involving steel to steel, without any drilling or dust.
- Almost all materials are a perfect fit for the large variety of nails, including steel, sand-lime masonry, solid bricks, concrete, and solid brick walls.
- The rapid-release feature makes it possible to quickly disassemble the magazine and remove stuck nails.
- Productivity will increase as a result of the powerful rechargeable battery with Li-Ion power that can power over 8,000 fixes on a single charge.
- The battery-LED status shows the tool’s status as well as how much battery power is left. By doing this, the work site is kept moving.
- If your battery runs out, a 10-minute charge enables you to fire at least 300 more nails. It takes 90 minutes for the battery to fully recharge.
What are Powder-Actuated Tools
A small, controlled explosion is used by powder-actuated tools, also known as direct fasteners and explosive-actuated fastening tools, to drive a nail, stud, or another specialized fastener into a solid base material like steel, concrete, or masonry.
Actuated Fastening Tool Applications
- For the quick and dependable installation of drywall tracks as well as for fixes even in tight spaces.
- To secure electrical connections, such as conduits, pipes, and cables, in all directions on floors, walls, and ceilings. The capacity for quick frequency fixes makes it possible to complete the work swiftly.
- In light-duty building construction applications, the magnetic nose piece accessory for the FGC 100 permits installations by driving nails through washers.
- Used as a temporary tacking method for steel beams and composite deck.
- The FGC 100’s unique EWI nose allows for the installation of insulation systems.
Conclusion
Gas-actuated tools, which use gas instead of powder to force a fastener into concrete or steel, can assist enhance safety and productivity in situations where powder-actuated counterparts may not be suitable. Utilize user safety knowledge and the training programs offered by tool manufacturers to reduce injuries. Hope you found this article useful and helps you to know more about the actuated fastening tool.